Has anyone on here ever loaded H4350 for a 150gr Nosler ABLR in 7mm-08?
Not a lot of data out there for it. The Hodgdon site says 45 to 48 grains for a 150gr Sierra HPBT, but that seems like it may be a little high. The reloading books do not even mention H4350 for 7mm-08 until the bullet gets to the 160gr mark.
I had another gentleman tell me to start at 43.0 grains and work up from there. He said he was running the 150gr ELDX in a 7mm-08.
First off I would like to say that I would normally trust the powder manufacturer's data over the bullet manufacturer's data. The problem for me is I know too low of a load is as dangerous as to high of a load. Really I'm just completely not sure where to start out with this combination.
Any advice is appreciated.
Not a lot of data out there for it. The Hodgdon site says 45 to 48 grains for a 150gr Sierra HPBT, but that seems like it may be a little high. The reloading books do not even mention H4350 for 7mm-08 until the bullet gets to the 160gr mark.
I had another gentleman tell me to start at 43.0 grains and work up from there. He said he was running the 150gr ELDX in a 7mm-08.
First off I would like to say that I would normally trust the powder manufacturer's data over the bullet manufacturer's data. The problem for me is I know too low of a load is as dangerous as to high of a load. Really I'm just completely not sure where to start out with this combination.
Any advice is appreciated.